INSTALLATION & OPERATION MANUAL SP834 Portable Printer System DOC#: MN-834-A
POWER SWITCH & AUTO POWER OFF This switch turns the printer on and off. If the printer is left on with no activity (no motion of the print head) for more than 1.5 minutes, the printer will automatically turn off. To turn the printer back on, turn off the power switch, then turn the power switch back on.
A fully discharged battery pack should take approx. 1.25 hours to be fully charged. It is safe to leave the unit always connected for a charge. After fast charge, the battery will trickle charge at a rate of C/50 which is (1/50 x 1.3aH) or 26 milliamps. RECHARGING THE PRINTER Insert 12VDC Probe into lighter outlet TOP OF FORM PUSHBUTTON (BLACK) The TOP OF FORM pushbutton will cause the paper to advance to the top of the next form.
ERASING CUSTOM MESSAGES To erase messages using the internal keypad, begin the erase sequence by pressing the CLEAR key. The printer will now print the following menu on the ticket: 0 – DO NOT ERASE 1 – ERASE CUSTOM MESSAGES To exit without erasing, press any key other than 1. To erase the custom messages press the ‘1’ key, “MESSAGE ERASED!” will print.
***ORIGINAL COPY*** OPERATION PROCEDURE T675 WITH SP825 DATACUBE & SP834 PORTABLE PRINTER To be performed as the final segment of delivery procedure. 1) Turn the SP825 ‘ON’ by depressing the P/B switch. Two short low volume beeps will occur and the green LED P/B SWITCH indicator flashes quickly. GREEN LED 2) With red lens inward, align SP825 in T675 bracket. One long loud volume beep occurs when data is successfully transferred to SP825.
4) Turn SP834 ‘ON’ red LED illuminates. 5) SP834 red LED indicator flashes rapidly, indicating communication. 6) Depress ‘RED’ print button. Red Print Button 7) Remove SP825 from SP834 printer holster. LOADING PAPER INTO THE PRINTER 1) Orient the printer as shown in the following drawing: Slide the paper tray cover back.
3) Curl back the top sheet as shown and feed the paper under the drag bar, through the opening and into the printer mechanism, keeping the paper evenly aligned. 4) Press the paper feed pushbutton (BLACK) while feeding paper into printer mechanism. Once the paper catches, the printer will continue feeding paper until the top of form mark is detected. Replace the paper try cover. The printer is now ready for operation.
©2009 Pub. No.
