User's Manual

9. If the battery becomes wet, there is a risk of fire, shock, shorting the electrical
system, or corrosion. Dispose of the battery immediately in accordance with the
local laws in regards to proper battery disposal.
10. Do not place on an unstable surface or near the edge of a surface. The camera
may fall, resulting in damage to the camera or injury. If the camera has fallen and its
body is damaged, turn it off, remove the battery and dispose of the CAMERA GOGGLE
in accordance with laws for disposing electronics. Using the camera after its body
has been damaged may cause a fire or electric shock.
11. Never leave the CAMERA GOGGLE in direct sunlight. Never leave the Camera
in the trunk of a car or in a car on a warm or hot day. Direct sunlight or high
temperatures may damage the CAMERA GOGGLE or cause the housing to burst.
12. Do not use the CAMERA GOGGLE in a location where there is explosive gas, or
any other flammable material in the air. Doing so may cause a fire or an explosion.
13. If the camera is not going to be used for a long period of time, remove the
battery from the camera. This will prevent any possible excess heat or leakage of
battery fluid that may result in injuries or damage to nearby objects.
14. Do not attempt to check the LCD display while moving. If riding or otherwise in
motion, come to a complete stop and make sure you are not on a path that others
may use. When motionless, remove the goggle to look at the LCD status display.
13.0 BATTERY WARNINGS AND PRECAUTIONS
2. Use only appropriate refuse points for environmentally correct disposal of spent
batteries.
3. Batteries are to be inserted with correct polarity. See page ENG-6.
4. Parental guidance is necessary when installing or replacing battery.
5. Do not throw batteries into fire.
6. After use, always switch off the device. Take out battery to store the device.
7. The supply terminals are not to be short-circuited.
8. Do not drop, hit, or submit the battery to strong shocks.
9. Do not allow the battery to come into contact with fresh or salt water, or allow
the terminals to become wet.
10. If the battery is leaking and the battery fluid gets on your skin or clothing,
immediately rinse with clean water and seek emergency care.
11. Rechargeable batteries are only to be charged under adult supervision.
1. Only Liquid Image 3.7V 1150mAh batteries are to be used with the CAMERA GOGGLE.
ENG-19
14.0 COMMONLY ASKED QUESTIONS AND
TROUBLESHOOTING
1. Is the CAMERA GOGGLE water proof? The CAMERA GOGGLE is water resistant.
It is not intended for underwater use. However, it is designed to withstand rain, sleet,
and snow or a brief accidental submersion underwater. Be sure to always check
that your battery and memory compartments are completely sealed prior to
exposing them to moisture.
2. My CAMERA GOGGLE has stopped recording. If your camera stopped recording
photos or videos, check to see if the memory is full or if your battery is empty.
The LCD will display “FUL”, if your memory is full. If the battery is empty the
battery icon will not have any bars. It is also possible that your micro SD/SDHC
card may have failed. Try an alternate card.
3. My goggle fogs. The CAMERA GOGGLE is treated with anti-fog on the inside
lens, which should minimize any fogging under normal use conditions. Always air-dry
ENG-20
to the micro SD/SDHC card that was removed from the camera, you may checkt the card on
a computer to see if any files were recorded and if they appear to have recorded normally.
NOTE: Any large changes in temperature, exposure to extreme temperatures or
sudden jolts, including dropping your CAMERA GOGGLE may damage the camera
components. If you have not dropped your camera or caused damage through any
physical shaking or colliding of the camera with a hard object, or if you have not
caused exposure to extreme temperatures or temperature fluctuations, there may be
an issue of water leakage into one of the compartments.
5. My CAMERA GOGGLE is "FROZEN" (Turned ON, but not functioning). If your
camera is "frozen" or not functioning while turned on, you may need to reset the
camera functions. First, check to see if the memory is full. You will see the word
"FUL" displayed on the LCD screen. Also check to see if your battery is empty or low.
If that does not reset the functions of the camera, move to a clean and
dry environment, check that the camera is completely dry in accordance with the
CARE AND MAINTENANCE (section 10.0), then remove the battery. Reinsert the
ENG-21
Warning: TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THE INNER ELECTRONICS TO RAIN OR MOISTURE.
FOR AMERICAN USERS
The following advisory is included in accordance with the laws of the state of
California (USA)
WARNING:
This product contains chemicals, including lead on the internal electronic board,
known in the State of California to cause cancer, birth defects or other
reproductive harm. Wash hands after handling.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
FOR CANADIEN USERS
This Class B digital apparatus complies with Canadian ICES-003.
ENG-22
8. If the inside of the camera gets wet, immediately turn it off and dispose of the
battery. Then dispose of the CAMERA GOGGLE in accordance with laws for
disposing electronics in your country. Using the camera after any internal
compartments have become wet may cause a fire or electric shock.
3. Avoid jolts, drops, collision with other hard objects, or shaking of the CAMERA
GOGGLE. These movements may damage the components.
4. Never open the camera body with a screw driver. There is a risk of shock if you
touch the camera components.
5. Children under 13 years of age should never wear or operate the CAMERA GOGGLE.
6. Children age 13 to 17 should always have adult supervision with use of this
product. The CAMERA GOGGLE is not a toy and needs to be treated with the same
care as any other digital camera.
7. An adult age 18 or older should always dry the product thoroughly before
performing the battery replacement or before performing the transfer of image and
video files to a computer.
provides basic protection against wind, dirt, dust, snow and glare. The lens will not
withstand a severe impact. This lens does not protect against hard or sharp objects.
Care should be taken to avoid impact with hard or sharp objects.
GOGGLE.
.
!
!
your lens or use a micro bag or soft cloth. Using gloves, clothing or other abrasive
materials may remove the anti-fog coating when wet. If fogging occurs, it is possible
that your anti-fog coating has rubbed off. You may need to replace your lens.
4. My CAMERA GOGGLE is no longer working (no power). Your battery may be
completely drained or your micro SD/SDHC card may not be working. Thoroughly
dry the CAMERA GOGGLE as directed in the CARE and MAINTENANCE (section 10.0).
Check the Goggle for any loose parts or open ports. DO NOT OPEN THE FACTORY
SEALED BODY OF THE CAMERA. If there were any open ports, check to make
sure they are not wet. Be careful not to touch any camera components inside the
MEMORY COMPARTMENT or BATTERY COMPARTMENT. If the components
are wet, follow the CARE AND MAINTENANCE (section 10.0). Check that the
battery and the memory card are completely inserted. If that does not solve the
problem, remove the battery and the micro SD/SDHC card. Fully charge the battery,
then reinsert into the camera. If the battery was not the issue, check the
micro SD/SDHC card by inserting another card, preferably a different brand, into the
camera. Please note that micro SD/SDHC cards can fail. Be sure to use a card that
meets the camera's specifications (see section 3.2). And be sure to follow the
manufacturer's Care and Maintenance instructions. If you had previously recorded files
For more trouble shooting, visit our website's help section www.LiquidimageCo.com
or email our CUSTOMER SUPPORT at [e-mail].
LIMITED WARRANTY: See limited warranty form included with this product.
battery. Close the compartment door. Turn on the camera and retest the functions.
Video Tutorials for product usage and trouble shooting are available on the website.
Colors and Style May vary from what is shown on the packaging.
FCC ID: WGI-XSC-369 IC ID: 10385A-369