SDS

DWP-40 PPG LIQUID NAILS INTERIOR DRYWALL ADVANCED CONSTRUCTION
ADHESIVE
Product name
2
Product code
Date of issue
Version
00421999
6 November 2018
Section 15. Regulatory information
SARA 302/304
SARA 304 RQ
:
Not applicable.
Composition/information on ingredients
All components are listed or exempted.
United States inventory (TSCA 8b)
:
United States
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
California Prop. 65
No products were found.
SARA 311/312
Classification
:
CARCINOGENICITY - Category 1A
Talc , not containing asbestiform
fibres
≥1.0 - ≤5.0
SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE)
(Respiratory tract irritation) - Category 3
crystalline silica, respirable
powder (>10 microns)
≤1.0
CARCINOGENICITY - Category 1A
Name
%
Classification
Composition/information on ingredients
WARNING
: Cancer - www.P65Warnings.ca.gov.
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the Prevention of Pollution From Ships, 1973
Hazardous Material Information System (U.S.A.)
0
0
0
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Date of previous issue
8/7/2018
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks. Although HMIS® ratings and the associated label are not required on MSDSs or products leaving a facility under 29 CFR 1910.1200, the
preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark
and service mark of the American Coatings Association, Inc.
The customer is responsible for determining the PPE code for this material. For more information on HMIS®
Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Organization that prepared
the MSDS
:
EHS
:
:
:
:
:
:
2
*
2
0
( * ) - Chronic effects
United States
Page: 12/13