MSDS

LIQUID NAILS PANEL ADHESIVE LN-320
Product name
2
Product code
Date of issue
Version
LN320 (F1)
26 July 2014
First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
Notes to physician
:
:
:
:
:
4 .
Check for and remove any contact lenses. Immediately flush eyes with running
water for at least 15 minutes, keeping eyelids open. Seek immediate medical
attention.
Remove contaminated clothing and shoes. Wash skin thoroughly with soap and
water or use recognized skin cleanser. Do NOT use solvents or thinners.
Remove to fresh air. Keep person warm and at rest. If not breathing, if breathing is
irregular or if respiratory arrest occurs, provide artificial respiration or oxygen by
trained personnel.
If swallowed, seek medical advice immediately and show this container or label.
Keep person warm and at rest. Do NOT induce vomiting.
If ingestion, irritation, any type of overexposure or symptoms of overexposure occur during or persists after use of this
product, contact a POISON CONTROL CENTER, EMERGENCY ROOM OR PHYSICIAN immediately; have Material
Safety Data Sheet information available. Never give anything by mouth to an unconscious or convulsing person.
No specific treatment. Treat symptomatically. Contact poison treatment specialist
immediately if large quantities have been ingested or inhaled.
Use an extinguishing agent suitable for the surrounding fire.
Fire-fighting measures
Extinguishing media
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
In a fire or if heated, a pressure increase will occur and the container may burst.
Special protective
equipment for fire-fighters
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
:
5 .
Special exposure hazards
:
None known.
Suitable
:
Not suitable
:
Hazardous combustion
products
:
Decomposition products may include the following materials:
carbon oxides
metal oxide/oxides
Flammability of the product
:
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Avoid breathing vapor or mist.
Provide adequate ventilation. Wear appropriate respirator when ventilation is
inadequate. Put on appropriate personal protective equipment (see Section 8).
Stop leak if without risk. Move containers from spill area. Approach release from
upwind. Prevent entry into sewers, water courses, basements or confined areas. Wash
spillages into an effluent treatment plant or proceed as follows. Contain and collect
spillage with non-combustible, absorbent material e.g. sand, earth, vermiculite or
diatomaceous earth and place in container for disposal according to local regulations
(see Section 13). Dispose of via a licensed waste disposal contractor. Contaminated
absorbent material may pose the same hazard as the spilled product. Note: see Section
1 for emergency contact information and Section 13 for waste disposal.
Environmental precautions
Accidental release measures
:
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Personal precautions
:
Large spill
:
6 .
Stop leak if without risk. Move containers from spill area. Dilute with water and mop up
if water-soluble or absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Small spill
:
Page: 2/8
United States - Canada - Mexico