MSDS

LIQUID NAILS PANEL ADHESIVE LN-320
Product name
2
Product code
Date of issue
Version
LN320 (F1)
26 July 2014
Exposure controls/personal protection
8 .
If workers are exposed to concentrations above the exposure limit, they must use
appropriate, certified respirators. Use a properly fitted, air-purifying or air-fed respirator
complying with an approved standard if a risk assessment indicates this is necessary.
Respirator selection must be based on known or anticipated exposure levels, the
hazards of the product and the safe working limits of the selected respirator.
Safety glasses with side shields.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
Personal protection
Eyes
Skin
Respiratory
Consult local authorities for acceptable exposure limits.
:
:
:
Engineering measures
:
Use only with adequate ventilation. If user operations generate dust, fumes, gas, vapor
or mist, use process enclosures, local exhaust ventilation or other engineering controls
to keep worker exposure to airborne contaminants below any recommended or statutory
limits.
Hygiene measures
:
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Recommended monitoring
procedures
:
If this product contains ingredients with exposure limits, personal, workplace
atmosphere or biological monitoring may be required to determine the effectiveness of
the ventilation or other control measures and/or the necessity to use respiratory
protective equipment. Reference should be made to appropriate monitoring standards.
Reference to national guidance documents for methods for the determination of
hazardous substances will also be required.
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment will
be necessary to reduce emissions to acceptable levels.
TWA
=
Time Weighted Average
Hands
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
R
=
Respirable
OSHA 29CFR 1910.1200 Subpart Z - Toxic and Hazardous Substances
=
Z
>37.78°C (>100°F)
Liquid.
Not available.
Not available.
1.47
Not available.
2.4 kPa (17.7 mm Hg) [room temperature]
Not available.
Not available.
Boiling/condensation point
Melting/freezing point
Physical and chemical properties
Physical state
pH
Specific gravity
Vapor pressure
Vapor density
Odor
Color
:
:
:
:
:
:
:
:
:
Flash point
:
Closed cup: Not applicable.
Explosion limits
:
Lower: 9.9%
9 .
Density ( lbs / gal )
:
12.27
Page: 4/8
United States - Canada - Mexico