Operating Instructions

Sensor 01
Basic safety instructions
14
Print version 03/2021, English
2.4 Safety instructions of the sensor
The sensor is delivered with several pictograms and warnings as stickers. Due to the small size
of the product, these stickers can not be attached to the sensor. In the course of the assembly,
these stickers must instead be glued on in the vicinity of the sensor, for example on the housing
of the machine tool. Ensure that these stickers are checked at regular intervals. Damaged
stickers must be replaced immediately.
Fig. 4: Safety instructions on the machine tool (example)
1
2
3
2.5 Emergency information
In case of an emergency at the sensor, pull out the mains plug to put the sensor out of
operation. Check to see if there are any casualties.
SAFETY INSTRUCTION
Pull out the mains plug immediately in the event of a malfunction or
emergency!
This disconnects the sensor from the power supply and shuts it down
immediately.
Important information for your safety
You are responsible!
In any case, ensure that the safety instructions in chapter 2 "Basic safety
instructions" and the locally applicable safety regulations are observed and
complied with.
Important information in the data sheet of the coolant
Different coolants exist that can have different effects on your health. In an
emergency, read the data sheet of the coolant!
Behavior in an
emergency