Operating Instructions

Sensor 01
Startup
22
Print version 03/2021, English
5 STARTUP
5.1 Introductory safety notes
Personnel qualification
The following personnel are approved for "Startup":
 Trained, instructed operating personnel
 Specialists for special work on machine tool, cooling lubricant tank or
electrical system
Important information for your safety
You are responsible!
In any case, ensure that the safety instructions in chapter 2 "Basic safety
instructions" and the locally applicable safety regulations are observed and
complied with.
Wear the necessary personal protective equipment (PPE).
5.2 Installation
The sensor must be installed as shown in the installation plan. A typical installation is shown
below schematically.
Fig. 9: Installation plan
1
Sensor 01
2
Machine tool on which sensor 01 is installed
3
Intake hose
4
Outlet hose
5
Coolant tank
The following requirements must be satisfied for the installation site of the sensor:
 In the vicinity of the coolant tank
 No installation in potentially explosive areas
 Ideally installed in a vertical/horizontal arrangement (sensor not lying down, i.e. no
installation with the magnets horizontal to the ground)
 Work area around the sensor should be 1 meter
 Route the connections (cables and hose lines) between the components without tripping
hazards
Installation plan
Installation
location