Operating Instructions

Sensor 01

Taking out of operation

Print version 03/2021, English

7.3 Removal

Requirement:

 The identification was removed from the machine tool

 The information about taking the unit out of operation was read and understood

 The sensor is switched off

 Wear the necessary personal protective equipment (PPE)

 Take the information on the data sheet of the coolant into account

 Absorbent paper

Use the following procedure to remove the sensor:

1. Pull the mains plug out of the socket outlet.

2. Put down the plug at a place where you can see it. This prevents reconnection by

somebody else.

3. WARNING! Risk of a short-circuit! Ensure that the plug of the power cable is not

connected to a socket outlet. There is the risk of a short circuit if the electrically connected

sensor drops into the coolant tank.

4. WARNING! Risk of injury from contact with coolant. Although the sensor is

switched off, there can still be residues of the coolants on or in hose lines or in the product.

A direct contact of the coolant with the skin can cause diseases and health damage.

Inhaling the vapors or aerosols can cause irritation and diseases of the respiratory tract.

Wear the required protective equipment and observe the instructions on the data sheet for

the coolant.

5. Remove the supply hose line including the filter from the coolant tank. Use the absorbent

paper to collect escaping coolant.

Fig. 20: Removing the hose line

6. Press the Status button briefly.

Fig. 21: Starting the manual measurement