Operating Instructions

Sensor 01
Taking out of operation
Print version 03/2021, English
31
 A manual measurement is started.
 The sensor is emptied. After a few seconds, the pump should run dry and sound
different. This shows that there is no more coolant in the sensor.
7. Now, remove the outlet hose from the coolant tank.
8. Pull the sensor off the surface. It is attached with magnets only. It can be pulled off with
some force.
Fig. 22: Removing the sensor from the surface
Fig. 23: Sensor with hose lines
9. CAUTION! Risk of injuries from leaking coolant. It is possible that there are still
residues of the coolant in the hose lines. These residues can escape and pose a slip
hazard. Eliminate escaped coolant immediately. Clean immediately. Wear the required
protective equipment and observe the instructions on the data sheet for the coolant.
 The sensor is removed and can be cleaned.
Important removal information
Due to the cooling lubricant residues on the product, we recommend cleaning the
product promptly. This helps you to prevent the contamination of surfaces or
other products with cooling lubricant. Dispose of the cooling lubricant in
accordance with the instructions of the manufacturer.