Quick start guide
4
English
CONNECT AUDIO
Connect the audio source(s) to the Listen EVERYWHERE (LE) server
via the terminal block connectors on the rear panel. LW-100P units
may use the enclosed RCA connection cable provided
Note: The input connectors accept line-level audio inputs. The RCA connectors on the LW-
100P units are unbalanced sum-to-mono inputs. If stereo is required, connect the audio
source(s) to the (1)L and (2)R connectors and then select, “stereo”, in the Cloud Service.
(See Cloud Service Setup.)
NETWORK CONNECTION
Connect the LE server to your local area network (LAN) via the eth-
ernet port on the server rear panel, then plug in the power cable. A
ashing blue power LED indicates the server is booting up. Once a
network connection has been established, the blue power LED will
turn solid. The enclosed CAT6 cable may be used to connect the LE
server to the network router or network switch. The LE server and
smartphones must be on the same public network.
Quick Tip: 2.4 GHz bands tend to have higher trac; 5 GHz or dual-band access points
recommended in high-trac areas