Installation Guide

FT-86 LIT LOGOSFT-86 LIT LOGOS
FLAT SURFACE FLAT SURFACE INSTALLATION GUIDE
| 6839 CORALBERRY LN N, JACKSONVILLE, FL 32244 | P: [phone] | WWW.LIT-LOGOS.COM
INCLUDED PARTS
1 -
1 -
1 -
1 -
Lit Logos Control Box
Lit Logos BRZ/GT86/FRS/TRD logo
3M Strip (pre-applied)
Lit Logos decal
HOW TO INSTALL
1. Disconnect the car battery
4. Remove the backing from the 3M and adhere the logo
where you want it to be. Keep constant pressure on it for at
least 60 seconds.
Ensure the surface you are mounting the logo to is clean to
allow for a strong bond.
2. Find a at surface you want to mount the logo to.
Route the control box connector to the area you want to
mount the logo to.
You may need to remove the bumper to route the wire.
5. Find where you want to connect the logo to power.
Any 12V power source will work so you can select a fuse,
headlight wire, or even wire it directly to the battery.
A 5a fuse must be used with ANY power source you use.
Most commonly with an inline fuse connected directly to
the car battery.
6. Route the power and ground wire from the
control box to the location you chose to power
the logo, avoiding any high heat or moving parts.
7. Tuck the Control Box out of the way, but still within
reach of the front bumper where you installed the logo.
Be sure to place this somewhere that wont be hit by
road debris, direct water, or high heat. This is the brains
of the Lit Logo. It is water and heat resistant, but high
pressure water or extreme temperatures can damage the
electronics.
3. Connect the Lit Logo to the Contol Box using the
waterproof quick disconnect.
Ensure that the arrowsEnsure that the arrows
line up on the connectorline up on the connector and the red gasket is in place. and the red gasket is in place.
Thread the locking nut into place all the way to ensure aThread the locking nut into place all the way to ensure a
waterproof connection.waterproof connection.
8. Re-connect the car battery.
CONTINUED BELOW...