User's Manual

the LED will display a Green colour, when ENGAGED it will display an Orange colour.
ON/OFF BUTTON
This button turns the Cruise Control ON or OFF. Status LED will change colour as detailed above.
SET/ACC BUTTON (Set/Accelerate Functions)
This button has 2 functions. When the Cruise Control is in standby (Green LED) pressing this button
will SET (engage) the Cruise Control at your current speed. When the Cruise Control is engaged
(Orange LED) pressing this button will ACCELERATE (increase) the speed. One brief press will
increase speed by 1kph.
On AP300 and AP500 models pressing and holding the button will increase speed in a gentle and
progressive manner, holding the higher speed when the button is released.
On AP900 and AP900C models pressing and holding the button for approx 1.5-2 seconds will increase
speed by 10kph above current set speed. This is indicated by 2 brief beep tones when holding the
SET/ACC button for the required period.
RES/DEC BUTTON (Resume/Decelerate Functions)
The RESUME function allows you to return to your last SET speed. If you have applied the brakes to
disengage the Cruise Control (such as travelling through a small country town with lower speed limit),
pressing the RES button will return the vehicle to the last SET speed on the current journey. If the
Cruise Control or Ignition has been turned OFF this feature will not operate as the last speed memory
setting has been erased.
When the Cruise Control is engaged (Orange LED) it will decelerate the vehicle. One brief press will
decrease speed by 1kph.
On AP300 and AP500 models pressing and holding the button will decrease speed in a gentle and
progressive manner, holding the lower speed when the button is released.
On AP900 and AP900C models pressing and holding the button for approx 1.5-2 seconds will decrease
speed by 10kph below current set speed. Again, 2 brief 2 beep tones will confirm 10kph reduction is
activated.
IMPORTANT NOTE – The rate of vehicle deceleration can vary according to several factors
including going down long or steep gradients, towing, carrying loads etc. The Cruise Control cannot
apply the vehicle brakes, and the vehicle driver should be prepared to apply the brake pedal and take
control if speed is not reducing at the required rate.
231.000502A