User's Manual

COMPANY CONFIDENTIAL
16
1.7
1.7
1.7
MSA-5403-2G4C1-A3, gray 300mm
MSA-5103-2G4C1-A2, black 400mm
MSA-5403-2G4C1-A2, gray 400mm
CX870-3BB
Dipole
3.2
WINiZEN
W1E-WO-08
CX870-3HB
Dipole
2
MAG. LAYERS
EDA-8709-2G4C1-A66
CX870-3HB
PIFA
3
2.8
3010000243ID (DA-E670)
3010000218ID (DA-E750)
Notes about antenna changes:
1) Equivalent antennas from other manufacturers may be substituted, and then marketed without
a Class II permissive change
2) Equivalent antennas must be of the same type (e.g. dipole, PIFA, etc.), must be of equal or
less gain than the antennas listed and previously authorized under the same FCC ID, and must
have similar in band and out of band characteristics (consult specification sheet for cutoff
frequencies).
3) In case of new antenna types, or higher gain antennas, a Class II permissive change is
required and compliance with FCC section 15.203 must be met.
6.0.2 CX Power Settings Used For Modular Approval
6.0.3 FCC IC Warning Message
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.