User Manual

JukeBlox Networked Media Modules – CX Series
Datasheet
SMSC CX Module 39 Revision 2.8 (09-30-12)
11 Appendix 1: Certification Notices
Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.
CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to
operate the equipment.
Labeling requirements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
RF exposure warning
This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide
with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.
Information for the OEMs and Integrators
The following statement must be included with all versions of this document supplied to an OEM or integrator, but
should not be distributed to the end user.
This device is intended for OEM integrators only. Please see the full Grant of Equipment document for other
restrictions. This device must be operated and used with a locally approved access point.
Information To Be Supplied to the End User by the OEM or Integrator
The following regulatory and safety notices must be published in documentation supplied to the end user of the
product or system incorporating an adapter in compliance with local regulations.
Host system must be labeled with "Contains FCC ID: ZQO-CX870-3”X”“, FCC ID displayed on the label. The label
text should be updated according to the table shown in Ordering Guide section of this document. The proper letter
shown in Ordering Guide Part Number column should be substituted for “X”. For example, for the CX870-3B module,
the label text should be “Contains FCC ID: ZQO-CX870-3B“.
Antenna List
No. Manufacturer Model No. Peak Gain
1 SKYTECH UNION INC. 1-888-241-00 1.28 dBi for 2.4GHz
2 LEAD JUMP Development LTD. 1-888-241-00 0.84 dBi for 2.4GHz
3 Tyco Electronics 2174241-2 (Length of cable: 390mm) 2.67 dBi for 2.4GHz
4 Tyco Electronics 2174241-1 (Length of cable: 330mm) 2.19 dBi for 2.4GHz