Datasheet

13
0.2
3.0
8.2
2.6
SOLDER MASK
UNITS: mm
Adjacent Land Keep-out
and Solder Mask Areas
Adjacent land keep-out is the
maximum space occupied by the
unit relative to the land pattern.
There should be no other SMD
components within this area.
The minimum solder resist strip
width required to avoid solder
bridging adjacent pads is 0.2 mm.
It is recommended that two fiducial
crosses be place at mid-length of
the pads for unit alignment.
Note: Wet/Liquid Photo-Imageable
solder resist/mask is recommended.