User Manual
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Notice: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
The antenna(s) used for this transmitter must not be co-located of operating in conjunction with any other antenna or transmitter. This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. Ln order to avoid the possibility of exceeding the Fcc radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8inches) during normal operation.
Product Features LiteON BLE Module WB101N adopts nRF52810 Central Processing Unit as a high performance and low energy(Bluetooth Low Energy) transmitting/receiving module system. Being assembled with extremely compact size, total dimension is 14.3*14.3mm*2.1mm so as to perfectly support low energy Bluetooth 4.0 protocol, Bluetooth 4.2 Secure Connection and also part of Bluetooth 5.0 protocol to apply to all kinds of IoT and other wireless application.
MAC Address and other basic information Low energy application could be controlled by hardware serial port Able to decide packet length of any serial port freely and without limit Bluetooth forecast data is compatible with ibeacon mode. Transmission distance:10~30 Meter, class II Transmission rate:Up to 6Kbyte/s Supply voltage:1.8~3.6V(3.3V typical) Module dimension:14.3*14.3mm Operation temperature:-40°C ~85°C Note: *The lowest operation temperature for low voltage mode could be -25°C .
Product Specifications MAIN CHIPSET • Nordic nRF52810 FUNCTIONAL SPECIFICATIONS 2.4 GHz transceiver • -96 dBm sensitivity in Bluetooth® low energy mode • Supported data rates: 1 Mbps, 2 Mbps Bluetooth® low energy mode • -20 to +3 dBm TX power, configurable in 3 dB steps • On-chip balun (single-ended RF) • 4.6 mA peak current in TX (0 dBm) • 4.6 mA peak current in RX • RSSI (1 dB resolution) ARM® Cortex®-M4 32-bit processor, 64 MHz • 144 EEMBC CoreMark® score running from flash memory • 34.
192 kB flash and 24 kB RAM Nordic SoftDevice ready Support for concurrent multi-protocol 12-bit, 200 ksps ADC - 8 configurable channels with programmable gain 64 level comparator Temperature sensor Up to 32 general purpose I/O pins 4-channel pulse width modulator (PWM) unit with EasyDMA Digital microphone interface (PDM) 3x 32-bit timer with counter mode SPI master/slave with EasyDMA I2C compatible 2-wire master/slave UART (CTS/RTS) with EasyDMA Programmable peripheral interconnect (PPI) Quadrature decoder
Antenna information: Manufacture: OPTO Model No.: OPTO-BTM-02 Antenna Type: Printed Antenna Antenna Gain: 3.
PIN ASSIGNMENT
LIVE DEMO Step1. Download Nordic APP (nRF UART or nRF Toolbox) Step2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.