User's Manual

Page 8/10 LITE-ON
2.5 Ethernet port
 1×10/100/1000 BASE-T Ethernet (RJ-45) port with PoE PD
2.6 LED Indicator Function Definition:
The LED shall be enabled and disabled by software. Please see the table below for detailed
definition.
1) Blue: All Radios’ are up and user are connected
2) Orange: One of the Radio are Down
3) Green: All Radios are up
4) Red: No Network or Backhaul
2.7 Power Supply
The product shall be powered by
 Power Over Ethernet, comply with PoE 802.3 af/at
(Note, AP itself consumes less than 12.95W excluding USB usage)
 External AC to DC power supply :12V DC, 1.5A
2.8 Factory Default Reset
The product shall support an external factory default reset mechanism. Press and hold the
reset button “in the order of 50 seconds” (for reference only) to reset the AP to factory
defaults.
(Note: This hold time is controlled by software; please refer to software document separately)
2.9 Debug port
 External console port @RJ45 form factor
3. Software Requirement
Lite-On provide the basic firmware to verify the quality of hardware. The basic firmware
includes the below parts. See table-01.
Table-01 product SW platform
Boot loader: u-boot
System Linux kernel version 3.10
Wireless driver V3.4.11c or upper version