Installation Guide

ITEM NO.: LS-19371
ASSEMBLY INSTRUCTIONS:
WARNING: MAKE SURE POWER SUPPLY IS TURNED OFF AT MAIN BREAKER PRIOR TO INSTALLATION.
PLEASE READ THOROUGHLY. CAREFULLY UNPACK THIS LAMP AND PLACE ON A SOFT FLAT
SURFACE.
1. There are 2 pcs of Wire(B)and 3 pcs of Steel cable (C) connect Body(A) and Canopy(D),before you
install the lamp, please adjust the wire and steel cable length to determined height for your lamp.
2.Fasten the crossbar (J) to the ceiling outlet box with
Outlet box screw (K).
3. Connect the NEUTRAL(white) wire (N) of fixture to the
NEUTRAL wire (N) from power supply using wire connector(M).
Connect the LIVE (black)wire (L) of fixture to the LIVE
wire(L) from power supply using wire connector(M).
(The driver(F) has already been connected wiring Ok with fixture)
4.Connect the GROUND wire (H) of fixture to the ground wire (G)
from ceiling outlet box， using the wire connector (M) (Or attach
them to the crossbar (J) with the green Ground screw (I)).
NOTE: Never connect the ground wire to live or neutral power
supply wire. If outlet box does not have ground wire,
please connect the ground wire from fixture to crossbar.
5.Attach the canopy (D) to the crossbar (J) and secure
With screw (E).
※ PLEASE INFORM YOUR DEALER IMMEDIATELY IN CASE OF ANY PARTS SHORTAGE.
※ SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Use a 45W LED Panel ,Included but Irreplaceable
(J)CROSSBAR
(N)SUPPLY WIRE(NEUTRAL)
(G)SUPPLY GROUND WIRE
(I)GROUND SCREW
(N)DRIVER INPUT WIRE(NEUTRAL)
(L)SUPPLY
WIRE(LIVE)
(H)FIXTURE GROUND WIRE
(L)DRIVER
INPUT WIRE(LIVE)
(F)DRIVER
(K)
8-32x
1
2
"OUTLET
BOX SCREW(2PCS)
(D)CANOPY
(E)
8-32x1"SCREW(2PCS)
(C)STEEL CABLE
(B)WIRE
(A) BODY
(M)WIRE CONNECTORS(3PCS)