User Guide

Charge Point Installation
Disassemble Logo Cover
1. Remove 2x M4 screw with T20H bit.
2. Slide logo cover up and remove by
pulling from charging station housing.
3. Remove 6x M4 screws with T20H bit,
and open the top cover
.
4. Remove 2x M4 screw with T20H bit, and
remove r
ear mounting bracket.
Secure Mounting Bracket
Secure the main body mounting bracket to the
wall with the appropriate scr
ew.
Note: It is recommended to use four (4) screws
when mounting the bracket, however if the
preference is to only use two (2), please use
the middle two screw holes of the bracket.If
only two screws are used to fasten the
mounting bracket, the screws should pass
through the middle two screw holes of the
mounting bracket.
1. Fasten mounting bracket.
4-Hole Mounting
Installation
8