Installation Sheet

INTRODUCTION
The LED Volumetric Retrofit fits in place of your existing troffer lens/diffuser providing an even surface of light and
allowing you to upgrade to cost effective LED technology. The two piece design combines a frame and the lighting
panel. The robust frame fits onto the ceiling grid and creates a stable insert. The LED Volumetric Retrofit is latched
onto the frame and swung into final position. The LED lighting panel fits inside most existing troffers. It provides
quality light, offers easy installation, efficient to modernize the look of your fixtures, and reduces your energy use.
CRITICAL SAFETY INSTRUCTIONS: Installation should only be conducted by a qualified electrician in accordance with NEC and
any relevant local building codes.
LED VOLUMETRIC RETROFIT WARNINGS: Risk of fire or electric shock. LED Volumetric Retrofit kit installation requires knowl
-
edge of luminaires electrical system. If not qualified, do not attempt installation. Contact a qualified electrician. Luminaire wiring
and electrical parts may be damaged when drilling for installation of LED Volumetric Retrofit kit. Check for enclosed wiring and
components. Do not make or alter any open holes in the enclosure of wiring or electrical components during kit installation.
WARNING: Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions
shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of
the luminaire. Only those open holdes indicated in the photographs and/or drawings may be made or altered as a result of kit
installation. Do not leave any other open holes in an enclosure of wiring or electrical components.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
This LED Volumetric Retrofit kit shall only be installed into a UL/CUL listed luminaire with a steel enclosure.
DISCONNECT SAFETY INSTRUCTIONS:
WARNING - This is a current rated device. Use in applications involving amperage beyond its rating can be dangerous and cause
electrical fires. See note on this page for allowable current and voltage levels and do not exceed those levels.
DANGER - NEVER remove wires from product as contact with electricity can cause serious injury or death. Shut off power at the
circuit breaker or remove fuse when installing this product.
SAFETY NOTICE - Improperly installed electrical wiring can be dangerous and cause electrical fires. This product must be used
in accordance with the current rating and wire sizes listed.
COPPER to COPPER ONLY. Do not use on Aluminum. Temperature rating: 105° C (221° F) maximum. Flame Rated UL94V-0.
This product is intended for use in a UL/C-UL listed Fluorescent Recessed or surface-mounted luminaire, Type IC or Non-IC,
with the dimensions specified.
SAVE THESE INSTRUCTIONS
SAFETY INSTRUCTIONS AND WARNINGS
Note: Kit comes with Volumetric
pre-assembled to frame. You will
disassemble the frame and Volumetric
for installation.