Installation Sheet

7
LED VOLUMETRIC RETROFIT
INSTALLATION
Section 1
9. From the incoming electrical line, insert stripped wires
into the male disconnect. Connect ground wire (shown
on page 3) to troffer.
8. Attach the two provided seismic safety cables from
the lamp to the troffer using self-tapping screws as
needed. Screw tabs on other end of cables to inside
of troffer.
Panel Hangers
Driver
Seismic Safety Cable / Ground Wire
Seismic Safety Cable / Ground Wire
Green / Ground Wire
Grey
Purple
Cord with Mated
Wago Connectors
10. Hook up the power to the LED Volumetric Retrofit
using Wago quick connect. Apply luminaire label to
troffer.
Note: The seismic safety cables come pre-attached
to the lamp. Attach the other end to the troffer, not
the frame.
11. Locate the panel hooks (2) on the LED Volumetric
Retrofit and rotate them to the open or install position.