Installation Guide

3. Installation Preparation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 225
square feet (20.9 square meters).
This fan can be mounted with a downrod
on a normal or vaulted ceiling. The hanging
length can be extended by purchasing a longer
downrod (0.5in./1.27cm diameter). After installing
hanging bracket, continue to Section 5 on page 4
for those instructions. This fan can also be
mounted using flushmount installation only on
a normal ceiling. After installing hanging bracket,
continue to Section 6 on page 5 for those
instructions.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire cutters,
and rated electrical tape.
4. Hanging Bracket Installation.
page 3
ON
OFF
ON
OFF
hanging bracket
Vaulted ceiling
angle is not to
exceed 25 degrees.
downrod
installation
flushmount
installation
spring washers
outlet box screws
blade edge
7 feet
(2.13m)
(76cm)
30
inches
flat washers
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light
switch is turned to the OFF position.
WARNING: Failure to disconnect power supply
prior to installation may result in serious injury.
Remove existing fixture.
WARNING: When using an existing outlet box, be
sure the box is securely attached to the building
structure and can support the full weight of the
fan. Ensure it is clearly marked "Suitable for Fan
Support." If not, it must be replaced with an
approved outlet box. Failure to do so can result in
serious injury.
Install hanging bracket to outlet box using
original screws, spring washers and flat washers
(size 8 or M5) provided with new or original
outlet box.* If installing on a vaulted ceiling,
face opening of hanging bracket towards high
point of ceiling. Arrange electrical wiring
around the back of the hanging bracket and
away from the hanging bracket opening.
*Note: It is very important that you use the proper hardware when installing the hanging bracket as this will
support the fan. Please make certain that you purchase any hardware that is missing in order to install the
hanging bracket properly.
12 ft. - 15 ft.
12 ft. - 15 ft.
(3.66m - 4.57m)
(3.66m - 4.57m)