Installation Guide

page 6
7. Canopy Assembly.
8. Blade Assembly.
hanging bracket
screw
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely. Slide canopy cover up to
canopy, aligning rounded part of slotted holes in
canopy cover with screwheads in bottom of
canopy. Turn canopy cover to the right (clockwise)
until it stops.
motor
housing
blade
blade plate
blade arm
blade
attachment
screws and
washers
lock washer and
blade arm screw
Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in hardware packs. Hold 1 blade plate
up to a blade and align holes, as shown, and
then lower a blade arm over blade holes.
(Important: Be sure to install blades with ridged
side facing UP and flat side facing the FLOOR.)
Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers
from underside of motor. If plastic motor locks
are installed with blade arm screws, discard
plastic motor locks (save blade arm screws and
lock washers to secure blade arms). Align blade
arm holes with motor screw holes and attach
blade arm with lock washers and blade arm
screws. Before securing screws permanently,
repeat this procedure with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
canopy
screw
canopy cover
plastic
motor lock