Installation Guide

page 8
pull chain
glass shade
threaded washer
finial plate
finial
Raise glass shade in order to guide pull chains through
corresponding holes at the bottom of the glass shade.
Align threaded rod on light kit fitter with hole in
middle of glass shade and push up gently, allowing
threaded rod to come through hole. (Be sure pull chain
for fan operation does not rub against bulb during
operation.) Secure glass shade to light kit fitter with
threaded washer.
Note: Do not overtighten threaded washer as glass may
crack or break.
Align threaded rod with center hole in finial plate,
allowing pull chains to come through corresponding
holes in finial plate, and push up. Thread center pull
chain through hole in finial and tighten finial.
Note: Do not overtighten finial as glass may crack or
break.
9. Light Kit Assembly. (cont.)
10. Testing Your Fan.
diagram 1
diagram 2 diagram 3 diagram 4
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the pull
chain on switch housing. Start at the OFF position (no
blade movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull will
set the fan to LOW. Fourth pull will re-set the fan to
OFF setting. Test light with pull chain in the middle.
(diagram 1) If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Important: Do NOT remove weatherproof cover from
reverse switch.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
reverse switch
pull chains