Installation Guide

Page 1
IMPORTANT SAFETY INFORMATION
(Protect yourself. Read these instructions carefully and save
them for future reference).
THIS FIXTURE IS DESIGNED TO BE
MOUNTED TO A JUNCTION BOX
FLUSH TO THE CEILING.
WARNING: RISK OF SHOCK
Electric current can cause painful shock or serious injury
unless handled properly. For your safety, always:
• Turn off electrical power at fuse or circuit breaker box before
wiring fixture to the power supply.
• Turn off the power when you change lamps or perform other
maintenance.
• Ground the fixture to avoid potential electric shocks and to
ensure reliable starting.
• Double-check all connections to be sure they are tight and
correct.
• Wear rubber-soled shoes and work on a sturdy wooden
ladder.
This fixture is designed for use in a circuit protected by a fuse
or circuit breaker and to be installed in accordance with local
electrical codes. If you are unsure about your wiring, consult a
qualified electrician or local electrical inspector, and check your
local electrical code.
WARNING: RISK OF INJURY
Some metal parts in the fixture may have sharp edges. To prevent
cuts and scrapes, wear gloves when handling the parts.
Account for small parts and destroy packing material, as these
may be hazardous to children.
Use flashlight or alternate light source to light work area during
installation.
Assistance may be required to support fixture during installation.
REQUIRED TOOLS
• Safety glasses
• Ruler/Tape measure
• Phillips screwdriver
• Pliers
• Adjustable wrench
• Wire strippers
Description Quantity
1) Crossbar ........................................................1
2) Screw #8-32 x 1½" ......................................... 2
3) Screw #8-32 x 1" ............................................ 2
4) Green Ground Screw .....................................1
5) Wire Nuts ....................................................... 2
6) Canopy .......................................................... 1
7) Ground Wire...................................................1
8) Cord ...............................................................1
9) Strain Relief ...................................................2
10) Knurled Finial .............................................. 2
11) Ballast Base .................................................1
12) Ballast Socket .............................................. 1
13) Glass Shade ................................................ 1
14) Lamp ............................................................ 1
15) Threaded Rod .............................................. 3
16) Plastic Washer ............................................. 3
17) Ball Finial ..................................................... 3
INSTALLATION INSTRUCTIONS
Figure 1
All Mounting Hardware Included
Lamps Included
TULIP MINI-PENDANT
U212455T
6/04
IMPORTANT INFORMATION TO RECORD
Model No. (on box) , or 6 Digit No. (on UL label) : _____________
Ballast Name & No.: ______________________________________
Lamp No.: ______________________________________________
Date Installed: __________________________________________
CAUTION: WIRING AND FIXTURE OPERATION
Connect fixture to supply wires rated for at least 90ºC (194ºF).
Do not use fixture on dimming circuits.
FIXTURE PARTS LIST