Installation guide

TULIP PENDANT INSTALLATION INSTRUCTIONS-
Page 1 Residential Lighting Products / Acuity Lighting Group, Inc.
One Lithonia Way, Conyers, GA 30012
Phone: [phone], www.lithonia.com
IMPORTANT SAFETY INFORMATION
Protect yourself. Read these instructions carefully and save them for future
reference.
THIS FIXTURE IS DESIGNED TO BE FLUSH
MOUNTED TO CEILING
Hardware requirements will depend on the mounting method.
Determine fixture location, orientation and mounting method before
proceeding.
WARNING: RISK OF SHOCK
Electric current can cause painful shock or serious injury unless handled
properly. For your safety, always:
. Turn off electrical power at fuse or circuit breaker box before wiring
fixture to the power supply.
. Turn off the power when you change lamps or perform other
maintenance.
. Ground the fixture to avoid potential electric shocks and to ensure
reliable starting.
. Check all connections to be sure they are tight and correct.
. Wear rubber-soled shoes and work on a sturdy wooden ladder.
This fixture is designed for use in a circuit Protected by a fuse or circuit
breaker and to be installed in accordance with local electrical codes.
If you are unsure about your wiring, consult a qualified electrician or local
electrical inspector, and check your local electrical code.
WARNING: RISK OF INJURY
Some metal parts in the fixture may have sharp edges.
To prevent cuts and scrapes, wear gloves when handling the parts.
Account for small parts and destroy packing material, as these may be
hazardous to children.
Assistance may be required to support fixture during installation.
REQUIRED TOOLS
Safety glasses Pliers
Ruler/Tape Measure Adjustable wrench
Phillips screwdriver Wire Strippers
FIXTURE PARTS LIST
Description Quantity
1) Crossbar …………..…....1
2) Screw #8-32 x 1 ½” …...2
3) Screw #8-32 x 1”….......2
4) Green Ground Screw ...1
5) Wire Nuts ……………....2
6) Canopy ..….......…....….1
7) Ground Wire ….............1
8) Cord ..…………………..1
9) Strain Relief …………...2
10) Knurled Finial …….......2
11) Ballast Base ………..…1
12) Ballast Socket..………..1
13) Glass Shade ….........…1
14) Lamp ….………………..1
15) Threaded Rod ...….......3
16) Plastic Washer ……..…3
17) Ball Finial ……………...3
CAUTION: WIRING AND FIXTURE OPERATION
Connect fixture to supply wires rated for at least 90°C
( 194°F ). Do not use fixture on dimming circuits.
IMPORTANT INFORMATION TO RECORD
Model No. (on box), or 6 Digit No. (on UL label):
Ballast Name & No.:
Lamp No.:
Date Installed:
Fig.1
All Mounting Hardware Included.
Lamps not included unless noted on carton label.