Installation Guide

Page 3 of 3
LED IMPORTANT SAFETY INSTRUCTIONS
Installaon Instrucons
2ALT2/2ALT4
**Cauon: MAKE SURE LUMINAIRE IS MOUNTED TO A SECURE STRUCTURE. USE APPROPRIATE MOUNTING
HARDWARE TO INSTALL FIXTURE RATED FOR YOUR APPLICATION. FAILURE TO MOUNT FIXTURE CORRECTLY
COULD RESULT IN SERIOUSLY INJURY.
SAVE THESE INSTRUCTIONS
1. Remove fixture from packaging and inspect for damage. If damaged do not use; return your fixture to the
supplier or contact your local sales rep for replacements.
2. Place the
fixture in the appropriate 15/16” T-Bar ceiling structure.
3. Bend, by hand, the built in T-Bar clips to secure the fixture to the T-Bar ceiling. (see Figure 1)
4. Remove access plate and make electrical connecons from supply and properly ground as local codes dictate.
5. Reinstall access plate.
Figure 1: Built In T-Bar
Built In T-Bar Clip
2.BEND T-BAR CLIP
BY HAND AS SHOWN.
1.ROTATE T-BAR CLIP
ALONG THE GROOVE
STANDARD 1 1/2”
T-BAR
THESE CLIPS HAVE BEEN INVESTIGATED BY UNDERWRITERS
LABORATORIES INC. AND MEET THEIR REQUIREMENTS FOR SECURING
NAME TYPE "G"RECESSED FIXTURE TO CEILING FRAMING MEMBERS
AS REQUIRED BY THE NATIONAL ELECTRICAL CODE.