Installation Guide

BLT/BLC LED IMPORTANT SAFETY INSTRUCTIONS
U999350, Rev E, 09/19/2019
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI CONNAÎT
BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE LES RISQUES INHÉRENTS
Installation Instructions
ABOVE CEILING ACCESS REQUIRED. KEEP THESE INSTALLATION INSTRUCTIONS / CONSERVEZ CES INSTRUCTIONS
D'INSTALLATION
1. Leave carton endcaps on fixture, for protection, until installation has begun. (See Figure 1)
Figure 1: Protective Endcaps
2. Remove carton endcaps and place the fixture in the appropriate T-Bar ceiling structure.
3. Bend the built in T-Bar clips over the T-Bar ceiling to secure the fixture to the T-Bar ceiling or use hanger wire hole as
shown in Figure 2.
If using LATC clips, attach the LATC clips using the provided screws after the fixture is placed in the grid as shown in
Figure 3.
Figure 2: Built In T-Bar Clip
Figure 3: LATC Installation
(ORDERABLE OPTION)
BEND OUT HOOK 90 DEG. TO
ENGAGE T-BAR ALL (4) CORNERS
HANGER WIRE ATTACH POINT
HANGER WIRE ATTACH POINT
ONCE FIXTURE IS IN
GRID, ATTACH LATC
CLIPS (4) USING
PROVIDED SCREWS
(maximum 17 in-lbs)
STANDARD
1 ½” T-BAR
STANDARD 1 ½”
T-BAR
**Caution: MAKE SURE LUMINAIRE IS MOUNTED TO A SECURE T-BAR CEILING STRUCTURE. USE APPROPRIATE
MOUNTING HARDWARE TO INSTALL FIXTURE RATED FOR YOUR APPLICATION. FAILURE TO MOUNT FIXTURE CORRECTLY
COULD RESULT IN SERIOUS INJURY.