Installation Sheet
Table Of Contents
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
- Diffuser Removal
- NOTE: Do not attempt to remove Diffuser if screw is covered with aluminum tape. Aluminum tape is used on BLT IP5X fixtures and removing the tape may allow ingress of bugs or dust into the optical chamber.
- NOTE: The other Trim Ring should remain installed for any necessary maintenance.
U999368, Rev B, 11/17/2020
BLT/BLC LED IMPORTANT SAFETY INSTRUCTIONS
Diffuser Installation
1. To re-install the Diffuser after maintenance, slide Diffuser into Trim Ring that remained in the fixture.
2. Place the second Trim Ring on the end of the Diffuser and rotate up into the End Cap.
3. Push Trim Ring against End Cap and align keyholes. Push upwards until you hear a snap. Replace the Locking
Screw into the End Cap.
SAVE THESE INSTRUCTIONS
For any questions, please contact 1-800-705-7378.
Keyhole