Installation Guide

Page 3 of 3
LED IMPORTANT SAFETY INSTRUCTIONS
Installation Instructions
2GTL2/2GTL4
**Caution: MAKE SURE LUMINAIRE IS MOUNTED TO A SECURE STRUCTURE. USE APPROPRIATE MOUNTING
HARDWARE TO INSTALL FIXTURE RATED FOR YOUR APPLICATION. FAILURE TO MOUNT FIXTURE CORRECTLY
COULD RESULT IN SERIOUSLY INJURY.
SAVE THESE INSTRUCTIONS
1. Remove fixture from packaging and inspect for damage. If damaged do not use; return your fixture to the
supplier or contact your local sales rep for replacements.
2. Place the fixture in the appropriate 15/16” T-Bar ceiling structure.
3. Bend, by hand, the built in T-Bar clips to secure the fixture to the T-Bar ceiling. (see Figure 1)
4. Remove access plate and make electrical connections from supply and properly ground as local codes dictate.
5. Reinstall access plate.
Figure 1: Built In T-Bar
NEMA TYPE "G" RECESSED FIXTURES TO CEILING FRAMING MEMBERS
LABORATORIES INC. AND MEET THEIR REQUIREMENTS FOR SECURING
STANDARD 1 1/2" T-BAR
AS REQUIRED BY THE NATIONAL ELECTRICAL CODE.
THESE CLIPS HAVE BEEN INVESTIGATED BY UNDERWRITERS
2. BEND LOWER PORTION OF
T-BAR CLIP PERPENDICULAR
TO T-BAR AS SHOWN.
1. BEND BY HAND TO
ENGAGE T-BAR
ALL (4) CORNERS.