Installation Guide

ManualsBrandsLithonia Lighting ManualsOther4 in. Matte White Recessed Gimbal LED Module (2700K)



LithoniaDownlighting  PartNo.CJ5201106Rev.A

OneLithoniaWay/Conyers,GA30012

800‐315‐4935/www.lithonia.com Page4of15



INSTALLATIONINSTRUCTIONS

4”‐4BL,4G1BaffleandGimbalLEDModules

5”‐5BL,5G1BaffleandGimbalLEDModules

” ‐

6BL, 6G1 Baffle and Gimbal LED Modules

4. Plug orange connector from the module into the mating orange connector just installed into the recessed can. Push

the wires and mated connectors up into the recessed can. DO NOT LET THE MODULE HANG UNSUPPORTED BY

THE ORANGE CONNECTORS. (See Figure 5)

5. Once all connections are complete, squeeze each pair of torsion springs together and place into brackets inside

fixture. Releases springs, and gently push trim into fixture until flush with ceiling. (See Figure 6)

6. INSTALLATION COMPLETE.

Torsion Spring Adapter (TSA5 and TSA6 sold separately)

WARNING - RISK OF FIRE OR ELECTRIC SHOCK

. Luminaires wiring, power supply, or other electrical parts may be

damaged when drilling for installation of retrofit assembly hardware. Inspect wiring and components for damage. Only those

open holes indicated in the photographs and/or drawings may be made or altered as a result of kit installation. Do not leave

any other open holes in an enclosure of wiring or electrical components.

You may require the TSA5 (5”) or TSA6 (6”) (Figure 8) option if you are retrofitting

an old-style can or a remodeler that does not have torsion spring brackets.

1. Remove the (3) screws around the perimeter inside of your existing can and

keep them.

NOTE: IF THRE ARE NO SCREWS TO REMOVE, YOU WILL

HAVE TO TEMPORARILY REMOVE CAN FROM CEILING TO DRILL

HOLES

Drilling Holes for TSA5 or TSA6 (Remodeler-Style Cans)

1a. Unlock ceiling clips and remove remodeler can from ceiling.

1b. Supporting the can while suspended, temporarily insert the TSA5 or TSA6 bracket, hooks upward, inside the can

and flush with the edge of the can.

1c. Using the TSA5 or TSA6 bracket-slots as a template, mark (3) hole locations with a center punch or writing utensil

inside can.

1d. Drill three appropriate sized holes to accommodate the (3) screws, and reinstall can into ceiling.

2. Reinsert the TSA5 or TSA6 into the can with the hooks facing upward. Line up the slots with the holes and align the

bottom of the TSA5 or TSA6 flush with the can.

3. Drive the (3) screws through the TSA5 or TSA6 bracket-slots and into the can to secure into position.

4. Refer back to the “INSTALLATION – 5” and 6” LED MODULE” section for further instruction.

RECOMMENDED DIMMING SWITCHES

The Lithonia LED Modules are compatible with standard incandescent (Triac), electronic low voltage (ELV), and magnetic

low voltage (MLV) dimmers. A list of recommended dimmers, to help with your installation, can be found on

www.lithonia.com

by searching for 4BL, 5BL, 6BL, 4G1, 5G1, or 6G1. Exclusion from the list does not mean a dimmer will

not work in conjunction with our LED modules, just that it has not been tested by Lithonia Lighting. It is also recommended

that you contact your specific dimmer manufacturer for any details or concerns since each dimmer and application is

unique.

Figure 8