Installation Guide



LithoniaDownlighting  PartNo.CJ5201106Rev.A
OneLithoniaWay/Conyers,GA30012
©20011 Acuity Brands Lighting, Inc., 4/13
800‐315‐4935/www.lithonia.com Page2of15


INSTALLATIONINSTRUCTIONS
4”‐4BL,4G1BaffleandGimbalLEDModules
5”‐5BL,5G1BaffleandGimbalLEDModules
6
” ‐
6BL, 6G1 Baffle and Gimbal LED Modules

WARNING: Prior to installing the fixture, disconnect ALL power supplies to the unit. To prevent wiring damage or abrasions, do
not expose wiring to edges of sheet metal or other sharp objects. This module may be installed into TYPE IC or NON-IC
installations. For TYPE NON-IC INSTALLATION ONLY: No insulation may be placed over the top of or within 3” (76mm)
of the fixture.

The retrofit kits is accepted as a component of a luminaire where the suitability of the combination shall be determined by
CSA or authorities have jurisdiction. The contents of the retrofit kits are:
 LED Module
 Socket Adaptor
 Two Red Splice Connectors
 Instruction Sheet
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK.
Install this kit only in the luminaires that has the construction
features and dimensions shown in the photographs or drawings.

INSTALLATION – 4” LED MODULES (Model# 4BL AND 4G1)
(NOTE – pictures show L Series Baffle modules, but installation process for LED Gimbal Modules is identical)
Retrofit 4” Installation with Socket Adaptor into Existing or New Construction Recessed Can
:
1. Remove the existing lamp and reflector, leaving the socket hanging freely by the
wires. (Figure 1)
2. Securely screw socket adapter into socket inside the can. While
supporting the LED module, plug the orange connector of socket
adapter into the LED module’s mating orange connector.
DO NOT LET THE MODULE HANG UNSUPPORTED BY THE
ORANGE CONNECTORS. (Figure 2)
3. Once all connections are complete, gently push the LED trim into
the recessed can opening until clips engage inside of can, and the
trim is flush with the ceiling surface.
NOTE: If installing into a retrofit-style housing with internal ceiling
support clips, be sure to offset the clips on the trim with the clips inside
can.
4. INSTALLATION COMPLETE.
Retrofit 4” Installation with Hardwire Connection Kit
:
1. Remove the existing lamp and reflector, leaving the socket hanging freely by the wires
2. Cut existing socket wires inside the recessed can close to the socket, and discard
the socket.
3. Remove the socket adapter from the box. Cut both adapter wires close to the
socket adapter and away from the orange connector, and discard the socket.
Remove the (2) red splice-connectors from the hardwire kit bag. Pair the housing
and orange connector wires by color into each red connector. Firmly squeeze the
metal U-shaped insert into the wires. Flip the cover closed to secure and insulate
the connection. (See Figure 3)
Figure 2
Figure 3
Figure 1