Installation Guide

ManualsBrandsLithonia Lighting ManualsAll Lithonia LightingLithonia Lighting Gimbal LED Modules 5'' LED Directional Recessed Fixture



LithoniaDownlighting  PartNo.CJ5201106Rev.A

OneLithoniaWay/Conyers,GA30012

800‐315‐4935/www.lithonia.com Page3of15



INSTALLATIONINSTRUCTIONS

4”‐4BL,4G1BaffleandGimbalLEDModules

5”‐5BL,5G1BaffleandGimbalLEDModules

” ‐

6BL, 6G1 Baffle and Gimbal LED Modules

4. While supporting the LED module, plug connector from the module into the mating connector just installed into the

recessed can. Push the wires and mated connectors up into the recessed can. DO NOT LET THE MODULE HANG

UNSUPPORTED BY THE ORANGE CONNECTORS. (See Figure 2)

5. Once all connections are complete, gently push the LED trim into the recessed can opening until clips engage inside

of can, and the trim is flush with the ceiling surface.

NOTE: If installing into a remodeler-style recessed can with internal ceiling support clips, be sure to

offset the trim clips away from the black clips inside can.

6. INSTALLATION COMPLETE.

INSTALLATION – 6” AND 5” LED BAFFLE AND GIMBAL MODULES (BAFFLE MODEL# 6BL AND 5BL; GIMBAL

MODEL# 6G1 AND 5G1)

(NOTE - pictures show L Series Baffle modules, but installation process for LED Gimbal Modules is identical.)

Retrofit 5” and 6” Installation with Edison Base Socket Adaptor into Existing or New Construction Recessed Can

1. Remove the existing lamp and reflector, leaving the socket hanging freely by the

wires.

NOTE: If your can does not have (2) torsion spring retention

brackets inside, see the “Torsion Spring Adapter” section prior to

going further.

2. Securely screw socket adapter into socket inside the

can. Plug the orange connector of socket adapter into

the LED module’s mating orange connector. (Figure

DO NOT LET THE MODULE HANG UNSUPPORTED

BY THE ORANGE CONNECTORS. (Figure 5)

3. Once all connections are complete, squeeze each pair of torsion springs together and

seat inside of brackets in fixture. Release springs, and gently push trim into fixture until

flush with ceiling. (Figure 6)

4. INSTALLATION COMPLETE.

Retrofit 5” and 6” Installation with Hardwire Connection Kit

1. Remove the existing lamp and reflector, leaving the socket hanging freely by the wires.

NOTE: If your can does not have (2) torsion spring retention brackets

inside, see the “Torsion Spring Adapter” section prior to going further.

2. Cut existing socket wires inside the recessed can close to the socket, and discard the

socket.

3. Remove the socket adapter from the box. Cut both adapter wires close to the socket

adapter and away from the orange connector, and discard the socket. Remove the (2)

red splice-connectors from the hardwire kit bag. Pair the housing and orange connector

wires by color into each red connector. Firmly squeeze the metal U-shaped insert into

the wires. Flip the cover closed to secure and insulate the connection. (See Figure 7)

ure 4

Figure 5

Figure 6

ure 7