Instructions / Assembly

U999350, Rev B, 11/14/2016
BLT LED IMPORTANT SAFETY INSTRUCTIONS
Cleaning the Diffuser
 Cleaning of the outside of the diffuser can be done with a soft cloth and water.
 The diffuser does not require removal and can be cleaned from the outside. However, if maintenance of
LEDs is required, the diffuser is removable.
Diffuser Removal
1. Locate screw on the end cap of the fixture. This will require above grid access.
2. Remove and retain screw. Press Trim Ring Locking Pins in towards the diffuser. Pull Trim Ring down and
away from End Cap while Trim Ring Locking Pins are depressed. Trim ring will disengage from endcap and
can be removed.
NOTE: Do not attempt to remove Diffuser if screw is covered with aluminum tape. Aluminum tape is used
on BLT IP5X fixtures and removing the tape may allow ingress of bugs or dust into the optical chamber.
3. Set aside removed trim ring; it will be re-used. Grasp the end of the Diffuser where the Trim Ring was
removed and angle down and away from fixture to remove.
NOTE: The other Trim Ring should remain installed for any necessary maintenance.
Screw Placement
Trim Ring
Locking Pin
End Cap
Trim Ring
Diffuser