Instructions / Assembly
Page 3
LED IMPORTANT SAFETY INSTRUCTIONS
Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory
statements.
Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and
Conditions, please visit www.acuitybrands.com.
Acuity Brands Lighng, Inc. assumes no responsibility for claims arising out of improper or careless installaon or handling of its products.
ABL LED General Warnings, Form No. 503.203
© 2016 Acuity Brands Lighng, Inc. All rights reserved. 04/01/16
Never connect components under load.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire
insulaon.
Unless individual product specificaons deem otherwise: Never connect an LED product directly to a
dimmer packs, occupancy sensors, ming devices, or other related control devices. LED fixtures must be
powered directly off a switched circuit.
Unless individual product specificaons deem otherw
ise: Do not restrict fixture venlaon. Allow for
some volume of airspace around fixture. Avoid covering LED fixtures with insulaon, foam, or other
material that will prevent convecon or conducon cooling.
Unless individual product specificaons deem otherwise: Do not exceed fixtures maximum ambient
temperature.
Only use fixture in its intended locaon.
LED products are Polarity Sensive. Ensure proper Polarity before insta
llaon.
Electrostac Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be
worn during all installaon or servicing of the unit.
Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter
performance.
Some components inside the fixture may not be serviceable. In the unlikely event your unit may require
service, stop using the unit immediately and contact an ABL represen
tave for assistance.
Always read the fixtures complete installaon instrucons prior to installaon for any addional fixture
specific warnings.
CAUTION: RISK OF PRODUCT DAMAGE