Installation Guide

2 of 16
CPANL SURFACE MOUNT KIT
-
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION DE CPANL KIT DE MONTAGE EN SURFACE
INSTRUCCIONES DE INSTALACIÓN DE CPANL KIT DE MONTAJE EN SUPERFICIES
REQUIRED TOOLS: SUPPLIED HARDWARE KIT:
A B C D E F G H
ADDITIONAL SUPPLIES MAY BE NEEDED DEPENDING ON THE TYPE OF CEILING FIXTURE IS BEING MOUNTED TO:
Masonry Anchors and Screws
Wood Screws
INSTALLATION:
TURN OFF THE POWER AT BREAKER !
Assemble hanger side brackets to hanger center bracket –
 Place hanger side brackets with the flat side down. Use locating tabs to orient side brackets. Hanger center brackets will only sit flat on
hanger side brackets in the correct orientation, see Figure 2A.
 Use outer set of holes for 1x4 and 2x4 installations, use inner set of holes for 2x2 installations.
 Use smooth headed screws (provided) to fasten center bracket to side hanger bracket, see Figure 2B.
 Fully tighten and repeat on other side.
DESCRIPTION QTY
A
TOGGLE NUTS 4
B
8-32 x 1” TOGGLE BOLT 4
C
HANGER CENTER BRACKET 1
D
HANGER SIDE BRACKETS 2
E
SMOOTH HEAD M3 BRACKET SCREWS 4 + 1 spare
F
MOUNTING HINGES 2
G
LATCH WITH TETHER 2
H
ROUND HEADED SCREWS 8 + 2 spare
Two-Person Installation
E (x4)
E
Figure 2B
1
2
D
E
E
C
E
E
D
2X2
2X4 / 1X4
Figure 2A