Installation Guide

SAVE THESE INSTRUCTIONS!

INSTALLATION INSTRUCTIONS

SAVE THESE INSTRUCTIONS!

ELM2 LED

CAUTION: For safety and proper operation, read and follow instructions carefully before installation.

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR SIGNIFI-

CANT PROPERTY DAMAGE- For your protection, read and follow these warnings and instructions carefully before installing or maintaining this

equipment. These instructions do not attempt to cover all installation and maintenance situations. If you do not understand these instructions or

additional information is required, contact Lithonia Lighting or your local Lithonia Lighting distributor.

WARNING:

RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS ENERGIZED.

WARNING: RISK OF FIRE- Lamps are hot. Keep combustible material away from hot parts. Observe lamp manufacturer’s warnings,

recommendations and restrictions on lamp operation and maintenance. Make sure lamps are correctly installed.

WARNING: DO NOT USE ABRASIVE MATERIALS OR OTHER SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE FIXTURE,

WHICH MAY RESULT IN PERSONAL INJURY.

WARNING: RISK OF PERSONAL INJURY- This product may have sharp edges. Wear gloves to prevent cuts or abrasions when removing

from carton, handling, installing and maintaining this product (WHERE APPLICABLE).

• Before wiring to power supply, turn off electricity at fuse or circuit breaker.

• Disconnect AC power and unplug battery before servicing.

• Consult your local building code for approved wiring and installation.

• May be used outdoors under cover. (10°C- 40°C).

• Do not let power supply cord touch hot surfaces.

• Do not mount near gas or electric heater.

• Do not install a damaged ﬁ xture.

• This product must be installed in accordance with the applicable installation codes and ordinances.

• Proper grounding is required to ensure peronal safety (WHERE APPLICABLE).

• All service shall be performed by qualiﬁ ed service personnel. This product must be installed and maintained in accordance with the applicable

installation codes by a person familiar with the construction operation of the product and the hazards involved.

• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.

• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.

• Do not use this equipment for other than intended use.

Patent # US: D473,672

D483,511

D484,272

® LED Series

IMPORTANT SAFEGUARDS

PAGE 1
INSTALLATION INSTRUCTIONS ELM2 LED CAUTION: For safety and proper operation, read and follow instructions carefully before installation.
PAGE 2
INSTALLATION INSTRUCTIONS NOTE: This unit should be mounted ONLY through a pair of the preformed keyholes onto a 4” “OCTAGON” junction box, or through a pair of the keyhole knockouts onto a 4” SQUARE junction box. Feed the fixture leads through the mounting plate and make connections to AC power supply. Dress the wires into the junction box. Secure the mounting plate onto the junction box with a minimum of two screws. Use only Flexible Conduit with this unit. Must be used with 4” j-box.
PAGE 3
INSTALLATION INSTRUCTIONS INSTALLATION & MAINTENANCE A. Normal Operation: When the unit is functioning properly, with power applied, the “TEST” switch will be illuminated red. B. To Test: Press the “TEST” switch. The fixture will remain illuminated. When switch is released, the lamps will go off. NOTE: See important battery information before testing. TEST switch To Open Housing: Press both circular snaps at the bottom of the housing.
PAGE 4
INSTALLATION INSTRUCTIONS WIRING DIAGRAMS NOTE: Unused input lead must be properly insulated with wire nut or other approved method NOTE for HO models: Use of 10-12 AWG stranded wire required to connect remote lamp heads to maintain operating voltage when remote fixtures are connected to the emergency lighting equipment.