Installation Guide

INSTALLATION INSTRUCTIONS

SAVE THESE INSTRUCTIONS

and deliver to owner after installation

CHICAGO APPROVED 50 & 100 WATT EMERGENCY

LIGHTING UNIT

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS

AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR

SIGNIFICANT PROPERTY DAMAGE. For your protection, read

and follow these warnings and instructions carefully before installing

or maintaining this equipment. These instructions do not attempt

to cover all installation and maintenance situations. If you do not

understand these instructions or additional information is required,

contact LITHONIA LIGHTING or your local LITHONIA LIGHTING

distributor.

WARNING: RISK OF ELECTRIC SHOCK - NEVER CONNECT

TO, DISCONNECT FROM, OR SERVICE WHILE EQUIPMENT IS

ENERGIZED.

WARNING: RISK OF FIRE. Lamps are hot. Keep combustible

material away from hot parts. Observe lamp manufacturer’s warnings, recommendations and restrictions on lamp operation and

maintenance. Make sure lamps are correctly installed.

WARNING: DO NOT USE ABRASIVE MATERIALS, OR OTHER SOLVENTS. USE OF THESE SUBSTANCES MAY DAMAGE

FIXTURE, WHICH MAY RESULT IN PERSONAL INJURY.

WARNING: RISK OF PERSONAL INJURY - This product may have sharp edges. Wear gloves to prevent cuts or abrasions when

removing from carton, handling, installing and maintaining this product.

IMPORTANT SAFEGUARDS: When using electrical equipment, basic safety precautions should always be followed, including

the following:

• Before wiring to power supply, turn off electricity at fuse or circuit breaker.

• Disconnect A.C. power and unplug battery before servicing.

• Consult your local building code for approved wiring and installation.

• May be used outdoors under cover (20°C - 50°C / 68°F - 122°F).

• Do not let power supply cord touch hot surfaces.

• Do not mount near gas or electric heaters.

• Do not install a damaged ﬁ xture.

• This product must be installed in accordance with the applicable installation codes and ordinances.

• Proper grounding is required to ensure personal safety. (WHERE APPLICABLE)

• All service shall be performed by qualiﬁ ed service personnel. This product must be installed and maintained in accordance with the

applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved.

• Equipment should be mounted in locations and at heights where it will not readily subjected to tampering by unauthorized

personnel.

• The use of accessory equipment not recommended by the manufacturer will void product listing and warranty and may cause an

unsafe condition.

• Do not use this equipment for anything other than its intended use.

• The AC voltage rating of this equipment is speciﬁ ed on the product label. Do not conect equipment to any other voltage.

PAGE: 1 of 3

PAGE 1
INSTALLATION INSTRUCTIONS CHICAGO APPROVED 50 & 100 WATT EMERGENCY LIGHTING UNIT READ AND FOLLOW ALL SAFETY INSTRUCTIONS WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE. For your protection, read and follow these warnings and instructions carefully before installing or maintaining this equipment. These instructions do not attempt to cover all installation and maintenance situations.
PAGE 2
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS: NOTE: Max mounting height is 10 ft to achieve at least 1 ft-candle of illuminance in emergency mode. 1. Remove the front cover. 2. Mount the equipment securely in place on the wall. Two additional KEY HOLE mounting holes are located at the top of the unit housing in addition to the J-BOX mounting holes. These two (2) additional mounting slot holes must be used when the unit is mounted to the wall. Additional chain support may be required by local codes.
PAGE 3
INSTALLATION INSTRUCTIONS TESTING: NFPA 101 Life Safety Code requires that all emergency lighting equipment be functionally tested every 30 days for a minimum of 30 seconds and tested annually for a full 90-minute duration. Written records of the testing are to be kept for examination by the authority having jurisdiction. TROUBLESHOOTING: 1. The emergency lights DO NOT operate and: a. If the charge indicator light is OFF - Check that the circuit breaker for AC supply is ON. b.