Installation Guide



Page4of4

LEDIMPORTANTSAFETYINSTRUCTIONS



SECTION2:SERVICING(DisconnectallpowertotheIBHLEDhighbaybeingservice.ReadLEDsafetyinstructionsonpage1)
1) Toaccessthedriver,removethetwoscrewsattheendsoppositethesafetycableside.
2) Rotatetopdriverhousingtoitssideandremovescrewholdingthechannelcover.FIGURE3,DIAGRAMBANDC.
3) Slidethechannelcoveroffitssecuringclips.
4) Markallwiringbeforeremovingthebaddriver.Installnewdriverinthesamelocation.Followwiringdiagramondriver.

5) MakesuretoinstalltheEMIferritecoreontothepowerleadsofthenewdriverifpresentinyourassembly.Inserttheblack,
whiteandgreenwiresfromthedriverintotheEMIferritecorehole.OneEMIferritecoreperdriver.
6) UseonlyULlisted
90C(orgreater)wiringandconnectors.Makesuretopushallwiringbackintothedriverhousingbefore
rotatingthedriverhousingtoclosedposition.Donotletwiringgetcaughtoutsidethetwoassemblies.
7) Tocleanlens,removeonebottomendcoverclosesttothesafetycableandslidelensout.
NOTE:LEDhousingismadefrom
aluminumsheets.Donotovertightenscrewswhenre‐installingtheendcover,thiswilldamagethescrewholes.
8) IfIBHLEDfixturedoesnotcomewithlens,donottouchtheLEDSwhenservicingtheunit.
9) Reinstallthelensandendcoverwhencleaningisdone.Glossside
oflensfacesfloor.SEEFIGURE3DIAGRAMA.

Five‐yearlimitedwarranty.Warrantytermsarelocatedat(U459430REVJ1/20/16)
www.acuitybrands.com/customerresources/term_and_conditions.aspx