Installation Guide

Page 2 of 8

UT459805

LBL4/LBL8 LED IMPORTANT SAFETY INSTRUCTIONS

Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and

Conditions, please visit www.acuitybrands.com.

Our Brands Indoor/Outdoor Indoor Lighting Outdoor Lighting Controls Daylighting

Lithonia Lighting Gotham American Electric Lighting DARK TO LIGHT SunOptics

Carandini Mark Architectural Lighting Antique Street Lamps LC&D

Holophane Peerless Hydrel ROAM

RELOC Renaissance Lighting Tersen Sensor Switch

Light Concepts Winona Lighting Synergy

Acuity Brands Lighting, Inc. assumes no responsibility for claims arising out of improper or careless installation or handling of its products.

ABL LED General Warnings, Form No. 503.203

✓ Never connect components under load.

✓ Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire insulation.

✓ Controls for dimming, auto-sensing, or remote control of a luminaire that are not factory-wired to the

luminaire must be checked for compatibility with the luminaire prior to installation. LED fixtures must be

powered directly off a switched circuit.

✓ Unless individual product specifications deem otherwise: Do not restrict fixture ventilation. Allow for some

volume of airspace around fixture. Avoid covering LED fixtures with insulation, foam, or other material that

will prevent convection or conduction cooling.

✓ Unless individual product specifications deem otherwise: Do not exceed fixtures maximum ambient

temperature.

✓ Only use fixture in its intended location.

✓ LED products are Polarity Sensitive. Ensure proper Polarity before installation.

✓ Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be worn

during all installation or servicing of the unit.

✓ Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter

performance.

✓ Some components inside the fixture may not be serviceable. In the unlikely event your unit may require

service, stop using the unit immediately and contact an ABL representative for assistance.

✓ Always read the fixtures complete installation instructions prior to installation for any additional fixture

specific warnings.

✓ Always ensure that the electrical distribution system is up to NEC (and any applicable local code)

requirements.

✓ Verify that power distribution system has proper grounding. Lack of proper earth ground can lead to fixture

failure and may void warranty.

CAUTION: RISK OF PRODUCT DAMAGE