Installation Guide

Page 4 of 8
UT459805
LBL4/LBL8 LED IMPORTANT SAFETY INSTRUCTIONS
A: Remove knockout from center of fixture housing as shown.
B: With power off, lift fixture housing to ceiling, centering knockout over outlet box and parallel to walls. Mark ceiling
with pencil for mounting holes through (2) 1/4" x 3/8" slots. Drill 1/8" pilot hole at each location (if drill did not
encounter ceiling joist, enlarge hole in ceiling to accommodate toggle bolt).
A: With power off, hold fixture up to outlet box and pull wires into fixture housing through the knockout hole.
B: Secure fixture housing at each end to ceiling with #10 wood screws or toggle bolts, depending on structural
conditions.