Installation Guide

Lithonia Lighting

Downlighting

One Lithonia Way / Conyers, GA 30012

800-315-4935 / www.lithonia.com

INSTALLATION INSTRUCTIONS

Part Number: >Revision D<

Page 4 of 11

LKA3, LKA4, LKA5 NEW CONSTRUCTION

ADAPTER

LKABH HANGER BARS

LKA3

120V ONLY LKA4, LKA5

NEW CONSTRUCTION ADAPTER INSTALLATION

1. NOTE: when deciding on fixture placement take into account joist

placement and electrical wiring requirements. Your ceiling material

must be non-combustible.

2. Install NEW CONSTRUCTION ADAPTER( purchased separately)

by positioning the LKABH BAR HANGERS (purchased separately)

between the ceiling joists and nailing in the attached nails to secure

in place. (Figure 4 & 5)

3. Disconnect all power prior to installation. Pull supply wire through

ADAPTER hole. Remove the appropriate pry-out knockout with

screw driver. Open snap on cover on junction box by depressing

spring and allow cover to hang.

Using the provided wire connecters, make all connections inside the

Junction box.

Bring supply wires into box by shielded cable or Romex cable and

connectors (Purchased separately)

Connect the 120V HOT wire black to black; NEUTRAL wire white to

white; GROUND bare wire to ground, push wires carefully back into

junction box. Close snap on cover in place.

4. REMOVE the (3) SPRING CLIPS from the REMODEL FIXTURE

and discard.

5. Tilt Fixture junction box up through hole and position adapter spring

clips with alignment grooves and rectangular openings on

REMODEL CAN HOUSING. Push up for spring clips to securely

snap in and lock in place. (Figure 6)

6. After electrical inspection is approved, complete ceiling installation,

with the following cut out openings to

 LKA3= 3 1/4 inch diameter cutout.

 LKA4= 4 1/4 inch diameter cutout.

 LKA5= 5 5/8 inch diameter cutout.

Figure 4

Figure 5

Figure 6