Installation Guide

Lithonia Lighting

Downlighting

One Lithonia Way / Conyers, GA 30012

800-315-4935 / www.lithonia.com

INSTALLATION INSTRUCTIONS

Part Number: >Revision D<

Page 5 of 11

LK3, LK4, LK5 SERIES REMODEL FIXTURE,

AND LKA3, LKA4, LKA5 NEW CONSTRUCTION

ADAPTER

LKABH HANGER BARS

LK3 LKA3

120V ONLY

LK4, LK5 LKA4, LKA5

TRIM FOR MODELS LK3 LK4 LK5 INSTALLATION with GU10 50W

120VAC LAMP

1. Disconnect all power prior to installation. Remove protective cover

from socket.

2. With the Lamp installed in the trim, connect LAMP by twisting

clockwise on to FIXTURE SOCKET.

3. Gently push up TRIM into fixture opening until flush with ceiling.

Check that the installation is secure. (Figure7)

REPLACEMENT OF GU10 50W 120VAC LAMP

1. Disconnect all power prior to installation.

2. Remove trim from housing by pulling down from ceiling.

3. Disconnect LAMP by twisting counter-clockwise on to FIXTURE

SOCKET. Connect new LAMP by twisting clockwise on to FIXTURE

SOCKET.

4. Gently push up TRIM into fixture opening until flush with ceiling.

Check that the installation is secure. (Figure7)

TRIM FOR MODELS LK5 INSTALLATION

1. Disconnect all power prior to installation. Remove protective cover

from socket.

2. Snap the fixture socket into the REFLECTOR TRIM.

3. Squeeze the torsion springs together and position and place on to

brackets in fixture. Release springs and gently pushes up TRIM into

fixture opening until flush with ceiling. Screw in Lamp and check that

the installation is secure.

REPLACEMENT OF PAR30 50W/75W 120VAC LAMP

1. Disconnect all power prior to installation.

2. Disconnect LAMP by twisting counter-clockwise on to FIXTURE

SOCKET. Connect new LAMP by twisting clockwise on to FIXTURE

SOCKET.

Figure 7