Installation Guide

U0842 11/1/11 Page 1 of 4
LED IMPORTANT SAFETY INSTRUCTIONS
MNSL LED Striplight
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions,
and other hazards please read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
Installation and service of luminaires should be performed by a qualified licensed electrician.
Maintenance of the luminaires should be performed by person(s) familiar with the luminaires’ construction and
operation and any hazards involved. Regular fixture maintenance programs are recommended.
It will occasionally be necessary to clean the outside of the refractor/lens. Frequency of cleaning will depend on
ambient dirt level and minimum light output which is acceptable to user. Refractor/lens should be washed in a
solution of warm water and any mild, non-abrasive household detergent, rinsed with clean water and wiped dry.
Should optical assembly become dirty on the inside, wipe refractor/lens and clean in above manner, replacing
damaged gaskets as necessary.
DO NOT INSTALL DAMAGED PRODUCT! This luminaire has been properly packed so that no parts should have
been damaged during transit. Inspect to confirm. Any part damaged or broken during or after assembly should be
replaced.
Recycle: For information on how to recycle LED electronic products, please visit www.epa.gov.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible
contingency to meet in connection with installation, operation, or maintenance. Should further information be
desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s
purposes, this matter should be referred to Acuity Brands Lighting, Inc.
•
•
•
•
•
•
•
•
Disconnect or turn off power before installation or
servicing.
Verify that supply voltage is correct by comparing it
with the luminaire label information.
Make all electrical and grounded connections in
accordance with the National Electrical Code (NEC)
and any applicable local code requirements.
All wiring connections should be capped with UL
approved recognized wire connectors.




Allow lamp/fixture to cool before handling. Do not
touch enclosure or light source.
Do not exceed maximum wattage marked on
luminaire label.
Follow all manufacturer’s warnings, recommendations
and restrictions for: driver type, burning position,
mounting locations/methods, replacement and
recycling.



READ AND FOLLOW ALL SAFETY INSTRUCTIONS!
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
WARNING
RISK OF ELECTRIC SHOCK
WARNING
RISK OF BURN
Wear gloves and safety glasses at all times when
removing luminaire from carton, installing, servicing
or performing maintenance.
Avoid direct eye exposure to the light source while
it is on.


Keep combustible and other materials that can burn,
away from lamp/lens.
Do not operate in close proximity to persons,
combustible materials or substances affected by
heat or drying.


CAUTION
RISK OF INJURY
CAUTION
RISK OF FIRE