Installation Guide

Acuity Brands Lighting, Inc.
One Lithonia Way, Conyers, GA 30012
www.AcuityBrands.com
TROUBLE SHOOTING GUIDE
UOLWX1_Rev 9/14
Knuckle, Slipfi tter and Yoke Accessories are available (sold
separately).
Accessory installation
Follow steps 1 to 3.
Follow wiring instructions outlined in step 5 & 6 to connect the
Accessory to the house supply wires and then to the fi xture.
7B. Push Wire Connectors into junction box. Align the fi xture
against the wiring box and tighten the Socket Set Screws to
secure fi xture in place.
Make sure all wiring access holes are sealed with weatherproof
silicone sealant (not included).
Trouble Shooing Guide
If this fi xture fails to operate properly, use the guide below to
diagnose and correct the problem.
If light does not come on:
• Verify that power is turned on at switch and breaker
• Verify that fi xture is wired properly
• Verify that line voltage is correct
If further assistance is required, contact:
Technical Support at: [phone]
This LED light provides low maintenance service with no bulbs
to change. Clean surfaces with mild soap and water. Do not use
abrasive materials such as scouring pads or powders, steel wool
or abrasive paper.
WARNING: There are no user serviceable parts inside fi xture.
DO NOT OPEN this fi xture.