Installation Guide

Installation Instructions for Power Sentry Emergency Battery Packs –QD MVOLT Series
Page 9
CAUTION
REFER TO LAMP SELECTOR TABLE
BEFORE CHANGING POSITIONS
LAMP SELECTOR (PS 1400 ONLY)
TEST SWITCH/PILOT LIGHT
CONNECT BLACK AND ORANGE
LEADS TOGETHER IF ORANGE
WIRE IS PRESENT
120 TO 277 VAC
UNSWITCHED LINE
BALLAST POWER CONNECTION
120 TO 277 VAC SWITCHED OR
UNSWITCHED LINE –
NOTE; VERIFY VOLTAGE RATING
ON LAMP BALLAST
MVOLT
BATTERY PACK
ONE LAMP INSTANT START BALLAST
Figure G
CONNECT BLACK AND ORANGE
LEADS TOGETHER IF ORANGE
WIRE IS PRESENT
CONNECT RED WIRE TO POINT “A”
FOR ONE LAMP OR TO POINT “B”
FOR TWO LAMP EMERGENCY
OPERATION
CAUTION
REFER TO LAMP SELECTOR TABLE
BEFORE CHANGING POSITIONS
LAMP SELECTOR (PS 1400 ONLY)
TEST SWITCH/PILOT LIGHT
120 TO 277 VAC
UNSWITCHED LINE
MVOLT
BATTERY PACK
BALLAST POWER CONNECTION
120 TO 277 VAC SWITCHED OR
UNSWITCHED LINE –
NOTE; VERIFY VOLTAGE RATING
ON LAMP BALLAST
“A”
SINGLE
EMERG. LAMP
CONNECTION
“B”
TWO EMERG. LAMP CONNECTION
TWO LAMP INSTANT START BALLAST
Figure H