Installation Guide

Part Number: RJ521353 Rev A
Revision Date: 11-19-12
Installation Instructions
TWH-LED
DELIVERY: Upon receipt of fi xture and accessories (packed separately), thor-
oughly inspect for any freight damage. All damage should be reported to the
delivery carrier. Compare the catalog description listed on the packing slip with
the fi xture label on the inside of the housing to be sure you have received the
correct merchandise.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
5 year limited warranty
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: [phone] • Fax: [phone] •
www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved.
Outlet box mounting:
1. Loosen the 2 captive screws in the front housing and remove front cover from fi xture.
2. Remove electrical splice compartment cover. Keep (2) 10-24 screws for reinstallation. See Figure A.
3. Remove center knock out and feed wires through.
4. Mount fi xture using dimensions shown in Figure B.
5. Make supply connections. Reinstall the (2) 10-24 screws and electrical splice component cover removed in step 2, making
sure no wires are pinched.
6. Replace front cover.
7. Tighten the 2 captive screws. Do not over tighten. Over tightening will cause stripping and void all warranties.
VIEW OF BACK CASTING
6"
(15.2cm)
10"
(25.4cm)
15-3/4"
(40cm)
15-1/4"
(38.8cm)
5"
(12.7cm)
3/8" Dia.
(1.0cm)
Mounting Holes
(3)
3" to bottom
of unit
7/8" Dia. K.O.
(2.2cm)
2-1/4" (5.7cm)
Figure BFigure A
Electrical splice
compartment
cover
8"
(20.3cm)