Installation Guide

AJ520066
Page 3 of 3
ZL1N INSTALLATION INSTRUCTIONS
LED IMPORTANT SAFETY INSTRUCTIONS
1. Apply pressure at opposite ends to pointed location as shown
in figure below to remove channel cover assembly
(Restrict from touching LED Boards with bare hands)
4. Slide end plate into end of channel and lock into place
via provided tabs, uninstall end plates to service LED
boards (Single mounting)
2. With access inside electrical chamber make all necessary
electrical connections (ensure luminaire is powered off)
5. Slide row aligner into end of channel to lock into place
(Continuous row mounting)
3. Ensure ground connection is made between channel and
channel cover before channel is closed
6. Repeat step # 1 to close fixture and fixture is ready for
hanging