Instruction Manual

page 4
1. Remove fixture components and parts pack(s). Check
that all parts are included. See Figure 1.
WIRING AND FIXTURE OPERATION
CAUTION: Connect fixture to supply wires rated for
at least 90° (194°F). Do not use fixture on dimming
circuits.
FIGURE 2: TO FLUSH MOUNT FIXTURE
Follow steps 2A to 9A.
2A. Attach crossbar to junction box with the (2) #8 x 1 ma-
chine screws passing through the slots. (Head of green screw
should face downward). See Figure 3.
3A.
Thread (2) #8 x 2¼" machine screws into the crossbar
about ¼". See Figure 3.
4A. Thread a hexnut onto one end of the large nipple about
1/4". Then thread end into the coupling on the front of the
pan. See Figure 1.
5A. Tighten the hexnut again against the coupling to lock the
nipple in place. See Figure 3.
6A. With the power off, hold the fixture firmly and connect
the copper ground wire from the fixture to the junction box,
by wrapping them under the head of the green ground screw
and securing them to the crossbar. (If house wiring includes
no ground wire consult your local electrical code for approved
methods). See Figure 3.
Assistance may be required to support fixture during instal-
lation
7A.Use wirenuts to connect the black fixture wire(s) to the
black power supply wire and white fixture wire(s) to white
power supply wire. See Figure 3 .
FOR PROPER CONNECTION, PLACE WIRENUT OVER
WIRES, TWIST CLOCKWISE UNTIL TIGHT.
8A.Align the keyholes in the fixture pan with the screws ex-
tending from the cross bar previously mounted the junction
box. See Figure 3.
9A.Install and rotate the pan to locate the screws in the slots.
Tighten the screws to secure the pan against the ceiling.
See Figure 3.
Proceed to Step 17.
Figure 2
Figure 3
GND
HEX NUT
#8-32 X 1
SCREW
CROSSBAR
#8-32 X 2
1
4
SCREW
WIRE
NUTS
KEYHOLE
GLASS
DIFFUSER
FINIAL
LARGE NIPPLE
NOZZLE
GROUND
SCREW
LAMP
DISCONTINUED