Specification Sheet

ManualsBrandsLithonia Lighting ManualsLightingWafer 8 in. White Selectable New Construction or Remodel Recessed Integrated LED Kit

Wafer™ LED Recessed Downlight

WF8

8" LED Switchable White

Color Temperature

IC/Non-IC

New Construction/Remodel

Speciﬁcations

Aperture: 6.9"

Ceiling opening: 8"

Over lamp trim: 8.9"

Height : 1.1"

All dimensions are inches (centimeters)

unless otherwise indicated.

FEATURES & SPECIFICATIONS

INTENDED USE — The 8" Wafer™ LED Downlight with Switchable White provides high-quality light output

and eﬃciency featuring a switch for easy color temperature adjustment - while eliminating the need

for recessed housings. The innovative, slim design allows for easy retroﬁt, remodel or new construction

installation from below the ceiling. The Wafer LED downlight is wet location listed – making it ideal for use

in a breadth of outdoor residential, hospitality, commercial and multifamily applications.

CONSTRUCTION — Aluminum die cast outer frame. Durable, powder coat paint to prevent rust. FT6 plenum

rated cable connector to connect from module to remote driver box. IC rated driver with convenience and

value of two remote selectable color temperature options, each with a setting choice to chose either 2700K,

3000K, and 3500K or 3000K, 4000K, and 5000K using the switch. Isolated driver integrated inside steel

remote box with four 7/8" knockouts with slots for pryout. Suitable for pulling wires with the 12 cubic-inch

wiring compartment to accommodate up to (6) 14 gauge insulated conductors, making the Wafer LED

Downlights much easier to wire in 2in/2out (plus ground) daisy-chain applications and contractor friendly.

INSTALLATION — Ideal for shallow ceiling plenum; no housing required. Steel spring clip for easy

installation. 8" cut out template is provided to ensure the correct size hole is cut into ceiling for proper

installation of the trim. Size of hole should not exceed 8 1/4 inches for this product. Suitable for installation

in t-grid and drop ceiling applications. 2" plenum space required for installation of the remote driver box.

OPTICS — Edge-lit LED technology uses light guided plate to distribute light. Polycarbonate lens provides

even illumination throughout the space.

ELECTRICAL — Connect directly to 120V power supply via provided UL recognized driver. High eﬃcient

driver with power factor > 0.9. Ambient operating temperature: -40°F (-40°C) to +104°F (+40°C). Dimming

down to 10% with most standard incandescent dimers (see list of approved dimmers). Replaces 100W

incandescent.

LISTINGS — CSA certiﬁed to US and Canadian safety standards. ENERGY STAR® certiﬁed product. Wet

location listed. Air Tight certiﬁed in accordance with ASTM E283-2004. Can be used to comply with California

Title 24 Part 6 High Eﬃcacy LED light Source Requirements.

WARRANTY — 5-year limited warranty. Complete warranty terms located at:

www.acuitybrands.com/CustomerResources/Terms_and_conditions.aspx

Note: Actual performance may diﬀer as a result of end-user environment and application.

All values are design or typical values, measured under laboratory conditions at 25 °C.

Speciﬁcations subject to change without notice.

DOWNLIGHTING WF8 LED - Switchable White

WF8

Series Lamp CCT/W/Lumens CRI Finish

WF8 8" wafer-thin LED downlight LED LED 27K30K35K 2700K/20W/1630L

3000K/20W/1800L

3500K/20W/1740L

30K40K50K 3000K/20W/1690L

4000K/20W/1850L

5000K/20W/1820L

90CRI 90CRI MW Matte white

MB Matte black

SN Satin nickel

ORDERING INFORMATION

For shortest lead times, conﬁgure product using standard options (shown in bold).

Example: WF8 LED 30K40K50KT 90CRI MW

Catalog

Number

Notes

Type

6.9"

(12.4)

8.9"

(17.0)

1.1"

(2.8)

Accessories: Order as separate catalog number.

WF8643 Pan U Universal new construction pan

WFJB U Remodel joist bar

Matte black Satin Nickel

WF8643 Universal New

Construction Pan

3.0 (7.7 cm)

1.3

(3.3 cm)

5.5 (14.0 cm)

Summary of content (4 pages)

PAGE 1
Catalog Number Notes FEATURES & SPECIFICATIONS INTENDED USE — The 8" Wafer™ LED Downlight with Switchable White provides high-quality light output and efficiency featuring a switch for easy color temperature adjustment - while eliminating the need for recessed housings. The innovative, slim design allows for easy retrofit, remodel or new construction installation from below the ceiling.
PAGE 2
[_LAMPTYPE] LED [_FAMILY] WF8 Downlight with Switchable White [_PRODUCTID]356d4c2b-dad5-4d2e-9a1c-31b8ab6e38e6 [_MOUNTING] RECESSED DOWNLIGHT [_TOTALLUMINAIRELUMENS]1638.1 [_INPUTWATTAGE]20.66 [_PHYSICALDIMENSIONS]-0.27, -0.27, 0 [_SCALED_TEST] SCALED FROM ABSOLUTE TEST: ISF 35709S-27K AND BASED ON NOMINAL SYSTEM PERFORMANCE. WF8 Switchable White 8" LED Wafer Module PHOTOMETRICS Distribution Curve Distribution Data Output Data Coefficient of Utilization Spacing to Mounting Height:1.
PAGE 3
[_LAMPTYPE] LED [_FAMILY] WF8 Downlight with Switchable White [_PRODUCTID]5731de75-e81c-4b5d-8d41-741ce8cc04d0 [_MOUNTING] RECESSED DOWNLIGHT [_TOTALLUMINAIRELUMENS]1698.1 [_INPUTWATTAGE]20.41 [_PHYSICALDIMENSIONS]-0.27, -0.27, 0 [_SCALED_TEST] SCALED FROM ABSOLUTE TEST: ISF 35715S-30K AND BASED ON NOMINAL SYSTEM PERFORMANCE. WF8 Switchable White 8" LED Wafer Module PHOTOMETRICS Distribution Curve Distribution Data Output Data Coefficient of Utilization Spacing to Mounting Height:1.
PAGE 4
WF8 Switchable White 8" LED Wafer Module WF8 LED 27K30K35K Color Temperature WF8 LED 30K40K50K 2700K 3000K 3500K 1630 1800 1740 90 90 90 Rated wattage 20.7 19.8 20.8 Lu/Watts 78.7 90.9 83.7 -40°C (-40°F) -40°C (-40°F) FCC Title 47 CFR, Part 15, Class B FCC Title 47 CFR, Part 15, Class B Class A Standards Class A Standards Lumens CRI Min. starting temp -40°C (-40°F) EMI/RFI FCC Title 47 CFR, Part 15, Class B Sound rating Class A Standards Input voltage 120V Min.